From OpenSCADAWiki
Configuring and using
- 1. Create an output transport of the type "Serial" and set its Identifier like to "merc200", one for each the devices' used serial bus.
- 2. Set proper address and timeouts of the Serial device.
- 3. Create and start a logical controller object or use any present one with need scheduling properties.
- 4. Create a logical parameter object and select the template for that, one for each the devices — enable the parameter.
- 5. Into the tab "Template configuration" of the logical parameter object you need to set:
- Transport — to Identifier of the transport into step 1.
- Network address — to logical address of the device on the bus under the transport in step 1.
- Coded address by the program Fixer+ — set the flag for counters coded by the program. Most likely the address will equal to apartment number.
- Read energy from reset — set the flag if you need the data.
- Read current values — set the flag to read current values.
- 6. RESULT: The logical parameter object will perform interaction and placing of gathered data to the parameter attributes.