From OpenSCADAWiki
Configuring and using
- 1. Create an output transport of the type "Serial" directly or by the "Sockets" gate, and set its Identifier like to "Serial.out_pulsar", one for each the devices' used serial bus.
- 2. Set proper address and timeouts of the Serial device.
- 3. Create and start a logical controller object or use any present one with need scheduling properties.
- 4. Create a logical parameter object and select the template for that, one for each the devices — enable the parameter.
- 5. Into the tab "Template configuration" of the logical parameter object you need to set:
- Transport — to address of the transport into step 1. Tracing for the address changing is supported.
- Address — to logical address of the device on the bus under the transport in step 1. Tracing for the address changing is supported.
- 6. RESULT: The logical parameter object will: dynamically create needed attributes accordingly to the attribute "Channels number" value and perform interaction and placing of gathered data to the parameter attributes. Also you are able to change some writable attributes.