From OpenSCADAWiki
Enter a message name below to show all available translations.
Found one translation.
Name | Current message text |
---|---|
h English (en) | {{CntHdr|Configuring and using}} :1. Create an output transport of the type "[[Special:MyLanguage/Modules/Sockets|Sockets]]" or "[[Special:MyLanguage/Modules/Serial|Serial]]" and set its Identifier like to "nik2303", one for each the device. :2. Set proper address and timeouts of the [[Special:MyLanguage/Modules/Sockets|Sockets]] or [[Special:MyLanguage/Modules/Serial|Serial]] device. :3. Create and start [[Special:MyLanguage/Modules/LogicLev|a logical controller object]] or use any present one with need scheduling properties. :4. Create [[Special:MyLanguage/Modules/LogicLev|a logical parameter object]] and select the template for that, one for each the devices — enable the parameter. :5. Into the tab "Template configuration" of the logical parameter object you need to set: :* ''Transport'' — to Identifier of the transport into step 1. :* ''Factory number of the counter'' — to proper factory number of the counter. :* ''Password'' — first level password, by default 1111111111111111. :* ''Coefficient of transformation'' — at accounting through the current transformers set the coefficient, by default it us — 1. :* Set flags for all parameters you need to read. :6. RESULT: The logical parameter object will perform interaction and placing of gathered data to the parameter attributes. |