From OpenSCADAWiki
Enter a message name below to show all available translations.
Found one translation.
| Name | Current message text |
|---|---|
| h English (en) | {{CntHdr|Configuring and using}} :1. Create an output transport of the type "[[Special:MyLanguage/Modules/Sockets|Sockets]]", set its Identifier like to "SSCP", one for each the device. :2. Set proper address of the [[Special:MyLanguage/Modules/Sockets|Sockets]] device to IP-address or host address of the remote device in the Ethernet network. :3. Create and start [[Special:MyLanguage/Modules/LogicLev|a logical controller object]] or use any present one with need scheduling properties. :4. Create [[Special:MyLanguage/Modules/LogicLev|a logical parameter object]] and select the template for that, one for each the devices — enable the parameter. :5. Into the tab "Template configuration" of the logical parameter object you need to set: :* ''Transport'' — to address of the transport into step 1. Tracing for the address changing is supported. :* ''Address'' — to logical address of the device on the bus under the transport in step 1. :6. RESULT: The logical parameter object will perform: :* reading files of lists ''listsDir'' for creation and content forming of the attribute "selList" of list of all allowed device's attributes; :* reading of content of the attribute ''list'' of selected device's attributes to dynamic form their representing attributes into the parameter object; :* reading of the dynamic formed representing attributes; :* checking for changes and writing of the dynamic formed representing attributes. |