From OpenSCADAWiki
Enter a message name below to show all available translations.
Found one translation.
Name | Current message text |
---|---|
h English (en) | {{CntHdr|Configuring and using}} :1. Create an output transport of the type "[[Special:MyLanguage/Modules/Serial|Serial]]" directly or by the "[[Special:MyLanguage/Modules/Sockets|Sockets]]" gate, and set its Identifier like to "MTP", one for each the devices' used serial bus. :2. Set proper address and timeouts of the [[Special:MyLanguage/Modules/Serial|Serial]] device. :3. Create and start [[Special:MyLanguage/Modules/LogicLev|a logical controller object]] or use any present one with need scheduling properties. :4. Create [[Special:MyLanguage/Modules/LogicLev|a logical parameter object]] and select the template for that, one for the devices on one bus — enable the parameter. :5. Into the tab "Template configuration" of the logical parameter object you need to set: :* ''Transport'' — to address of the transport into step 1. Tracing for the address changing is supported. :* ''Device address'' — to logical address of the device on the bus under the transport in step 1. Tracing for the address changing is supported. :6. RESULT: The logical parameter object will perform interaction and placing of gathered data to the parameter attributes. Also you are able to change some writable attributes. |