From OpenSCADAWiki
Enter a message name below to show all available translations.
Found one translation.
| Name | Current message text |
|---|---|
| h English (en) | [[File:LibsDevsDNP3Cfg.png|right|Configuration.]] {{CntHdr|Configuring and using}} :1. Create an output transport of the type "[[Special:MyLanguage/Modules/Sockets|Sockets]]", set its Identifier like to "DNP3", one for each the device-PLC. :2. Set proper address with port '''20000''' and timeouts of the [[Special:MyLanguage/Modules/Sockets|Sockets]] device-PLC. :3. Create and start [[Special:MyLanguage/Modules/LogicLev|a logical controller object]] or use any present one with need scheduling properties. The interaction period preferred to be about '''0.1''' second. :4. Create [[Special:MyLanguage/Modules/LogicLev|a logical parameter object]] and select this template for that, one for each the device-PLC — enable the parameter. :5. Into the tab "Template configuration" of the logical parameter object you need to set: :* ''Transport'' — to address of the transport into step 1. Tracing for the address changing is supported. :* ''Destination'' — remote station address in the integer range [0...65520]. :* ''Source'' — the same station address (source) in the integer range [0...65520]. :* ''Retry connection time'' — retry connection time in seconds, at the connection missing and no response detection. :* ''Poll events time'' — time in seconds of the events periodical polling (Class 1). :* ''Poll all time'' — time in seconds of the complete data requesting (Class 0,1,2,3). :6. RESULT: The logical parameter object will perform interaction and placing of the gathered data to the object "items", creation/placing and checking for commands of the proper attributes, created by the "itemsSet" instruction. :7. In the process of the working, through the tab "Attributes" of operational data, in addition to obtaining the result, it is possible to perform operative setup and control on: :* ''Items set by'' — for controlled items naming and definition as attributes and accessible for write. :* ''All items'', {Item attributes} — direct writing for the writable items. |