|
Written on: 18. 02. 2016 [21:38]
|
|
aminsalmani.science
amin salmani
Topic creator
registered since: 18.02.2016
Posts: 4
|
hi
i write new module for openscada. it is work for dnp3 protocol.i couldn't compile it because i dont know how should i create makefile.in file for my module.
since lack of time i need help.
any one know how should i work
thank you
[This article was edited 1 times, at last 18.02.2016 at 21:39.]
|
|
Written on: 19. 02. 2016 [09:49]
|
|
roman
Roman Savochenko
Moderator Contributor Developer
registered since: 12.12.2007
Posts: 3788
|
"aminsalmani.science" wrote:
i write new module for openscada. it is work for dnp3 protocol.i couldn't compile it because i dont know how should i create makefile.in file for my module.
At first, here already implemented the IEC-60870
And if you create a module to OpenSCADA then you need to read the manual where all needed information described!
Learn, learn and learn better than work, work and work.
|
